Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Dryer Vent Cleaning Across Chino
Dryer vent cleaning in Chino typically runs $149 – $289 for a full duct rodding and exterior hood inspection, and most homes are done in under two hours. The Inland Empire’s hot, dry air does something specific to lint: it bakes it into a dense, felted mat that hugs the duct walls, especially near the exterior hood where the hot air exits. That’s the vent failure most Chino homeowners never see until the dryer starts taking two cycles per load. If your dryer is running long, running hot, or leaving the laundry room smelling scorched, call Limestone Chimney Sweep at (855) 341-5439 for a free estimate. We serve all of Chino, including the 91710 and 91708 ZIP codes, and we carry the materials to fix what we find.
Most Chino homes fall into two camps: older mid-century tract and ranch houses off the 91710 downtown core, and newer master-planned construction in the 91708 Preserve area. Each has its own vent problems, and we see both every week. Our crews know the difference between a vent that needs cleaning and one that needs a transition-duct replacement before the first load of the week goes through.
Key Takeaways
- Dryer vent cleaning in Chino runs $149 – $289 for a standard single-story run; longer or multi-story runs cost more.
- Chino’s low humidity bakes lint into a hard mat at the exterior hood, so a vent that looks clear at the wall can be nearly blocked outside.
- We carry smooth metal transition duct to replace the crushed foil connectors common in older 91710 ranch homes.
- One visit can cover both the dryer vent and the chimney, since Limestone is a full-service ventilation and chimney company.
- Free estimates by phone: (855) 341-5439.
Styles & brands we work with
Why Limestone Chimney Sweep Is Chino’s Preferred Dryer Vent Cleaning Company
We’re a repair-capable operation, not a cleaning-only crew. That distinction matters in Chino, because a surprising number of “dryer vent cleanings” in this area end with the tech telling the homeowner they need a liner or a duct section replaced, but not having the parts to do it. We stock smooth metal transition duct, proper clamps, and termination screens on the truck. When we find a crushed foil connector or a felted lint plug in a 91710 ranch house, we fix it that visit, not on a follow-up scheduled two weeks out.
Chino homeowners also appreciate that we treat dryer vents and chimneys as one fire-safety category. The same hot, dusty conditions that leave creosote dry and flaky in a dormant chimney also harden lint inside a dryer duct. Limestone handles both, which means one call covers the full household ventilation picture. Warren Tilsley built our operation around that idea: diagnose, repair, restore, not just sweep and leave.
Our Dryer Vent Cleaning team works across the 91710 downtown grid and the newer 91708 Preserve development regularly. Response time to Chino from our Orange County base is typically same-week. We know the housing stock, we know the climate, and we know what a Chino dryer vent looks like after one Inland Empire summer.
Our Dryer Vent Cleaning Services in Chino
Full Dryer Duct Rodding and Lint Removal in Chino
We rod the full duct run from the dryer connection to the exterior hood, not just the first few feet behind the machine. In Chino, that last several feet near the exterior termination is where the felted lint collects. The dry air hardens it, and a partial cleaning that stops short of the hood leaves the real blockage in place. We clear the entire run and confirm airflow at the exterior cap before we call the job done.
Exterior Hood and Termination Screen Inspection in Chino
Chino’s dormant-season wildlife problem extends beyond chimneys. Birds and squirrels that nest in open roofing penetrations also pack lint and twig debris into dryer hoods that have missing or damaged flapper covers. Our inspection includes the full termination: we check the flapper, the screen, and the seal where the duct passes through the wall. If the hood is caked with felted lint or the flapper is stuck open, we clean and reseat it or tell you plainly if replacement is the better fix.
Transition Duct Replacement with Smooth Metal in Chino
The older ranch and tract homes in the 91710 core often still have foil or semi-rigid transition duct behind the dryer. These crush easily when the machine gets pushed back against the wall, and in Chino’s dry heat, the ridges become lint traps that harden over time. We replace foil and crushed connectors with smooth metal transition duct, cut to length and secured with the right clamps. This is not a generic hardware-store fix; we carry the parts to do it correctly as part of a standard visit.
Dryer Vent and Chimney Combination Service in Chino
Because Limestone is a full-service chimney and ventilation company, a single visit can cover the dryer vent and the chimney flue. That’s a practical option for Chino homeowners who use the fireplace occasionally through winter and the dryer year-round. One trip, both systems cleared and inspected. It’s the most efficient way to handle the two most common household fire risks in one appointment.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Common Dryer Vent Cleaning Problems We See in Chino Homes
- Felted lint mats at the exterior hood. Chino’s hot, low-humidity air bakes lint into a hard felt-like layer where the duct terminates outside. A vent that reads open at the wall connection is often 60 – 70% blocked at the hood by October.
- Crushed or kinked foil transition duct. In the 91710 ranch and mid-century tract homes, the space behind the dryer is tight. Foil connectors get crushed against the wall, and the ridges trap lint in a spot no “from-the-outside” cleaning will reach.
- Dormant-season wildlife debris in dryer hoods. The same birds and squirrels that nest in Chino’s open chimney crowns between seasons also work their way into roof vents and dryer terminations. A fall cleaning frequently turns into a screen-and-cap job.
- Runs over 25 feet with multiple elbows. Some of the two-story Preserve-area homes have longer, multi-bend duct runs that push dryer lint further and collect it in the bends. These runs need full-length rodding from both ends, not a six-foot brush from the wall.
Pricing for Dryer Vent Cleaning in Chino, CA
A typical dryer vent cleaning in Chino runs $149 – $289 for a single-story home with a standard run up to about 20 feet. Longer runs, two-story verticals, or multi-bend ducts in Preserve-area homes add $30 – $75. If we’re replacing the transition duct with smooth metal, that’s typically $35 – $80 depending on length and access. Exterior hood replacement, when the flapper is stuck or the screen is compromised, runs $45 – $120.
What affects your price in Chino: duct run length, number of elbows, single-story versus two-story, how long it’s been since the last cleaning, and whether the vent has been felted over by the dry air. We quote before work begins, and the estimate is free. No numbers change after we start unless we find something structural, and we’ll show you the camera footage before recommending anything beyond the scope.
See the difference
Before
After
Before
After
Before
AfterOne Chino Dryer Vent Call That Stayed With Us
A homeowner off the 91710 downtown-core grid called because her dryer was taking two cycles per load and the laundry room smelled faintly scorched. Our tech pulled the transition duct behind an older mid-century ranch dryer and found lint felted into a dense plug at the exterior hood, then rodded the full run out to the wall cap. We cleared it, re-secured the transition with a smooth metal elbow in place of the crushed foil, and the dryer was back to a single cycle that afternoon. That’s a typical Chino vent: clear at the wall, plugged at the outside, and fixable in one visit when the truck carries the parts.
Trusted Brands We Service in Chino
When a Chino dryer vent or chimney component needs replacement, we install named, warrantied parts, not generic hardware-store substitutions. Limestone works with professional-grade lines including DuraFlex for liner and duct components, HeatShield for flue restoration when a liner can be rehabilitated rather than torn out, and Famco and Copperfield products for caps, hoods, dampers, and ventilation terminations. That supply access means we don’t stop at the cleaning. If the vent needs a new hood or the transition duct is shot, we carry the fix on the truck and complete the job during the appointment.
We Also Serve Cities Near Chino
Limestone Chimney Sweep serves Chino and the surrounding Inland Empire communities, including Los Serranos, Ontario, Montclair, and Eastvale. If you’re just outside the Chino city limit and need dryer vent cleaning or a full chimney sweep and inspection, call us at (855) 341-5439 and we’ll get you on the schedule.
Serving Chino, CA — Our Local Coverage Area
We’re based in the Chino area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs – Dryer Vent Cleaning in Chino
Every 12 months for most Chino homes, and more often if the dryer runs daily for a large household or the vent terminates through a roof with multiple bends. Chino’s dry air felts lint faster than humid climates do, so a year in Chino packs more buildup into the duct than the same year in a coastal area. If your clothes are taking longer to dry, it’s time now, not at the 12-month mark. Call (855) 341-5439 for an exact recommendation based on your home’s setup.
If it’s crushed, kinked, or visibly ribbed with layers of trapped lint, yes. Foil transition duct is the weak point in most older 91710 ranch homes, and it’s often the reason a dryer still runs hot after a basic cleaning. We replace it with smooth metal transition duct cut to your space. The replacement is part of the visit, and we quote it before starting.
Longer duct runs and multiple elbows in newer Preserve construction are the usual cause. Lint collects in the bends, and the dryer’s moisture sensor keeps extending the cycle because the air isn’t leaving the duct fast enough. A full-length rodding from both ends clears it, and we’ll check the exterior hood flapper at the same time. If the vent is partially felted over at the termination, which Chino’s dry air does reliably, one cleaning restores normal dry times. Call (855) 341-5439 to get on the schedule.
Yes. The exterior hood is where Chino’s felted lint problem lives, and a cleaning that skips it is not a cleaning. We inspect the flapper, the screen, and the wall seal at every appointment. If the hood is clogged, we clear it. If the flapper is stuck or the screen is compromised, we show you and quote a replacement using Famco or Copperfield components.
Yes. Limestone Chimney Sweep handles dryer vents, chimney sweeping, and chimney repair under one roof. If your Chino home has a fireplace that sits dormant through the Inland Empire heat and a dryer that runs year-round, one visit covers both. It’s the most efficient way to address the two biggest fire-safety risks in the house. Call (855) 341-5439 and tell us you want both; we’ll book the combined appointment and quote it before we arrive.
Contact Limestone Chimney Sweep in Chino
If your dryer is running long, the laundry room smells hot, or you can’t remember the last time the vent was cleared, call Limestone Chimney Sweep at (855) 341-5439 today. We’ll give you a free estimate, talk through what your Chino home’s vent likely needs based on the housing stock and the climate, and get you scheduled. We carry the materials to fix what we find, from smooth metal transition duct to exterior hood components, so one visit usually ends with the dryer running on a single cycle again.
Written by Warren Tilsley, Owner at Limestone Chimney Sweep, serving Chino and the surrounding Inland Empire communities.